How to install compressor wheel on turbocharger?

How to install compressor wheel on turbocharger?

1.  Remove the turbo charger.

2. Remove the Exhaust Back Pressure Valve (EBPV) from the turbine housing.

   

3. Remove the wastegate E clip from the wastegate actuator rod end.

   

4. Remove the nuts (2) holding the wastegate actuator onto the compressor housing using a 10 mm socket.

5. Remove the compressor housing bolts (5) using a 5/16” or 8 mm socket.

6. Remove the compressor housing from the turbo

7. Using a 16 mm wrench loosen the compressor wheel by turning counter-clockwise. Remove the wheel off of the shaft.

   

8. Thread on the Anti Surge Compressor wheel onto the shaft. Tighten it down to 50-65 in-lb. Caution: Do not over tighten the compressor wheel onto the shaft!

9. Reinstall the compressor housing. Use a new compressor housing o-ring.

   

10. Install the bolts and tighten evenly in a star pattern to 12 ft-lb.

11. Install the EBPV onto the turbine housing and install the bolts. Tighten to 30 ft-lb. 

12. Reinstall the turbo using the instructions listed in step 1.